TriggerSmart Mark 2 Controller

About this product

The TriggerSmart MK2 system is a wireless-enabled addition to the TriggerSmart range, providing an affordable triggering solution for all photographers wanting to capture movement. The TriggerSmart MK2 system can be connected via cable or wirelessly to a variety of sensors, or the TriggerBeam or TriggerScout sensors to allow your camera sytem to be triggered by an IR beam, passive infrared (PIR), light or sound. 

The Mark 2 (DC2) Controller is connected to the Wireless Multi Sensor (WMS-1, available separately) via the wireless link.  The Controller is connected to the camera shutter release via a cable or using a wireless radio trigger. The Controller has 16 programmable channels and three trigger modes: manual, auto 1 shot and auto re-arm. Powered by x2 CR2032 batteries (not included). 

Key Features:
• Compact design and digital control features
• Digitally set delay and trigger time
• Delay time 1ms to 10 seconds
• Trigger (burst) time 0.1 to 10 seconds
• Burst or one shot firing mode
• Auto and manual trigger reset
• Manual override focus and trigger
• Works with other TriggerSmart products
• Long battery life with battery low indicators
• Compatible with most digital cameras, DSLR’s, Mirror-Less and Compact System Cameras. Even some video cameras

Specification

CONTROLLER

Trigger Input                            - Via 433Mhz wireless link for Sensor (available separately)

                                                - Wired input from Sensors (available separately) and other TS products

Wireless channels                   - 16 programmable channels

Digital Trigger Timer                - Digital readout for - 100 ms (1/10 sec.) to - 9.9 seconds

Digital Delay Timer                  - Short delay - 1 ms (1/1000 sec.) to 100 ms (1/10 sec.).

                                                - Long delay - 1000 ms (1/10 sec.) to 10 seconds.

Timing Accuracy                      - < 2%

Trigger Modes                          - Manual, auto 1 shot, auto re-arm.

Focus Activation                       - Manual activation.

Trigger Outputs                         - Camera and auxilliary

Sensor Modes                           - Flash, infrared beam, sound.

Power Requirements                 - x 2 PP3 batteries, high power type, one can be on standby

Power Consumption                  - About 25 milliamps.

Size                                           - (W)15cm x (D)10cm x (H)3.5cm.

Weight                                       - 200g

Waterproofing                            - IP53.

Temperature                              - 0 to 35˚ C. (operating).

Shock                                         - 10 Newtons.

Customer Reviews